Results 1 to 3 of 3
  1. #1
    150+ Forum Groupie
    Join Date
    Jan 2007
    Location
    East Yorkshire UK
    Posts
    267
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Transponder and vPilot

    My transponder switch is connected to an FDS SYS card and I am trying to set it up using IItcreator. I have various combinations of switch up/down but I cannot affect the Mode C window in vPilot. The Squawk Ident works fine.
    Has anyone anything to share on this puzzle?
    Barry
    a320sim.com

  2. #2
    150+ Forum Groupie
    Join Date
    Nov 2015
    Location
    Krefeld, GER
    Posts
    243
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Transponder and vPilot

    Barry,

    I am using a standard switch connected to an Arduino IO Card (Mobiflight) and can change Mode C without any problem. Happy to look up the offsets for you, if this helps.

    Michael

  3. #3
    150+ Forum Groupie
    Join Date
    Jan 2007
    Location
    East Yorkshire UK
    Posts
    267
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Transponder and vPilot

    My simulator buddy down the road has it working with SIOC and with wiring changes I could move to that method but I would prefer to leave the wiring alone. I don’t have an Arduino card in the pedestal.
    Thanks for your interest.
    Barry