Hello all,


I just posted a new video presentation about the OEM 737 cockpit conversion I started in 2011. It's about 45 minutes long and focuses on how I cut the airframe up and then put it back together in my basement. There is a short discussion at the end about my hardware and software setup, with Prosim737 and Prepar3d.


I've given this presentation each of the past two years at EAA Airventure in Oshkosh, WI. I hope you all enjoy it and I welcome your questions.


You can view it on YouTube at:


https://youtu.be/YaGVz9wZBis


Peter