A320 FMGS B50

[michael1508]

don't think there are any.
I guess, you need to program them yourself

[romeow]

Michael is right! Either you have got three joystick buttons you can assign within FMGS_Config.exe > Joystick Buttons or you might be successful to use FSUIPC with your keyboard keys and the corresponding offsets (see Jeehell's Advanced User Guide, page 25).

[DannyT]

Dear,
I try to configure my ECP. I use simple push button. When I calibrate the buttons, what to use Push, Release or Toggle? This is driving me crazy!

[romeow]

BTW You don't calibrate buttons you configure them. Axes are calibrated! Anyway, for buttons you use

Button Push Action

-Push Event (action= ON) -> in combination with Button Release action > Push Event (action=OFF)
-Toggle Event for ON/OFF (not used for ECP as far as I know).

[DannyT]

Ok. Thank you.
That means for ECAM Switch Panel equipped with push Buttons: Push Event in combination with release event?

[romeow]

No.
Button Push Action > select 'Push Event'
Button Release Action > select 'Push Event'

[Leonidas]

I have something similar with red button AP off during landing.
The first time works fine, but when I fly back without restart FMGS, when I press AP off red Master Warn and chime don't stop until I press red button again, but then light up FOs Stick Priority arrow and never goes away cos I dont have FO sidestick. I have Push Event --> CPT APTO and Release Event --> Nothing.
So, the first time works well, but not the second one.
Regards

[masterp]

I have something similar with red button AP off during landing.
The first time works fine, but when I fly back without restart FMGS, when I press AP off red Master Warn and chime don't stop until I press red button again, but then light up FOs Stick Priority arrow and never goes away cos I dont have FO sidestick. I have Push Event --> CPT APTO and Release Event --> Nothing.
So, the first time works well, but not the second one.
Regards

For AP red button on stick you have to config:
Push action: Push event
Release action: release
Both assign CPT APTO

On final to disconnect AP press this button twice as real life procedure.

[DannyT]

I have tried, but it does not work. I can not switch. If I press All, the screens runs with no stop possible all ECAM pages. Any idea what could be wrong?

[romeow]

Sorry, probably my mistake.

Button Push Action > select 'Push Event'
Button Release Action > select 'Release Event'

Keeping ALL pressed, pages swap. When you release the button ALL swapping should stop. Hope it will work!