FMGS software does not detect hardware

[drsalsa]

when the "configure controls" window pops up, the software refuses to detect the hardware when i move it to initialize and it wont show up in the drop down list. im running project magenta and cockpitsonic if that helps. is there anything i can do to fix it?

[jeehell]

when the "configure controls" window pops up, the software refuses to detect the hardware when i move it to initialize and it wont show up in the drop down list. im running project magenta and cockpitsonic if that helps. is there anything i can do to fix it?

have you installed EHID drivers?
I hope you are not running project magenta along my software...

[drsalsa]

yes i have EHID installed and I am using project magenta. Is that going to cause problems?

[iwik]

Hi,
JH software is used INSTEAD of Project Magenta. They both serve the same purpose.
Les

[drsalsa]

thanks for that. i already uninstalled everything to do with project magenta but now the issue im facing is that the FMGS_Config program will not detect my hardware when i move it to initialize. cockpitsonic has no trouble detecting hardware inputs. so now im trying to figure out how to interface cockpitsonic with the FMGS_Config. anything helps

[jeehell]

did you select the EHID/Cockpitsonic option during installation?
If so on which computer?

[drsalsa]

Yes i did select those. Everything is installed on the same PC running FSX

[jeehell]

you are running FMGS config alone? (i.e. NOT with the FMGS suite running at the same time)

[drsalsa]

ive tried running FMGS_config alone and with the suite open. Nothing ive done has worked so far

[jeehell]

did it worked with project magenta?