Results 1 to 5 of 5

Thread: MCDU Line Positioning Question

  1. #1
    500+ This must be a daytime job
    Join Date
    Jan 2009
    Location
    Tampa
    Posts
    538

    MCDU Line Positioning Question

    I looked at the manual and see where we can use the LSK/RSK to position lines to match hardware positioning. Is there a way to move the label lines too?

    Thanks.

    Buddy

  2. #2
    2000+ Poster - Never Leaves the Sim
    Join Date
    Mar 2008
    Location
    France,Nice
    Posts
    2,599

    Re: MCDU Line Positioning Question

    Hi

    If I remember well it is either CTRL+L to switch from line label to main line and vice versa, or maybe on the software faceplate clicking on the empty page button.

  3. #3
    500+ This must be a daytime job
    Join Date
    Jan 2009
    Location
    Tampa
    Posts
    538

    Re: MCDU Line Positioning Question

    hi, thank you for the reply, it was the empty page button.

  4. #4
    150+ Forum Groupie masterp's Avatar
    Join Date
    Jun 2015
    Location
    Ho Chi Minh City
    Posts
    224

    Re: MCDU Line Positioning Question

    Hi JL, is this possible to assign this empty button in FMGS_Config or assign a FSUIPC offset for this empty button ?
    Since the MCDU are Display only, so it will be more easier if we have this button assigned to adjust all the row and label.

    Thanks
    Vu

  5. #5
    2000+ Poster - Never Leaves the Sim
    Join Date
    Mar 2008
    Location
    France,Nice
    Posts
    2,599

    Re: MCDU Line Positioning Question

    that will be added in FMGS config.