Results 1 to 6 of 6

Thread: Offset for landing gear and brake panel

  1. #1
    Our new friend needs to reach 10 posts to get to the next flight level
    Join Date
    Jan 2016
    Location
    USA
    Posts
    7

    Offset for landing gear and brake panel

    I am looking for the offset for the landing gear mechanism and the brake panel landing gear led status.
    Any idea?

  2. #2
    150+ Forum Groupie
    Join Date
    Nov 2015
    Location
    Krefeld, GER
    Posts
    214

    Re: Offset for landing gear and brake panel

    Take Offsets from FSUIPC directly for mechanism and LED configuration

  3. #3
    Our new friend needs to reach 10 posts to get to the next flight level
    Join Date
    Jan 2016
    Location
    USA
    Posts
    7

    Re: Offset for landing gear and brake panel

    Thanks Michael, I did not even looked at FSUIPC but at the offset provided by JeeHell.

  4. #4
    Our new friend needs to reach 10 posts to get to the next flight level
    Join Date
    Jan 2016
    Location
    USA
    Posts
    7

    Re: Offset for landing gear and brake panel

    Also, I am using Mobiflight with the following offset:
    0BE8 - 0 - UP
    0BE8 - 16383 - Down.
    None works. I also tried the EventID to no avail.
    is this working for anyone? If so are you using the same values? These values works with the default aircrafts, but no Jeehell.

    Edit... I got it working, the Arduino board I was using
    had issues, could be because it was excited about the new year

  5. #5
    150+ Forum Groupie
    Join Date
    Nov 2015
    Location
    Krefeld, GER
    Posts
    214

    Re: Offset for landing gear and brake panel

    Hi Andy,

    great, it's working for you now. I assume, you are not on version B49 yet? With B49 the routine changed! You need to take the Jeehell offsets now:
    78ED/1 Byte =>value 81 for Up, 82 for Down

    So do not be irritated when updating to B49

    Best,
    Michael

  6. #6
    Our new friend needs to reach 10 posts to get to the next flight level
    Join Date
    Jan 2016
    Location
    USA
    Posts
    7

    Re: Offset for landing gear and brake panel

    Thanks. I got it working and setup the LED for red and green on the brake panel.