A320 FMGS B48

[tcane]

Hi Karsten,

Check you Bios-System-time respectively your Windows-Timesettings. Maybe you have changed your Batterie or something and the Bios reset to the default config. I had the same problem after i changed the battery of the motherboard.

Cheers
Florian

[Leonidas]

Hi
Anyone else with no needles in EGT?
Also sometimes flap sound doesn't stop after Full Flaps...
Regards

[pete_fuss]

Hello,

i can confirm, this morning i have also no needles in EGT!

Regards Pete

[Leonidas]

Hi
It would be nice if doors was open in lower ECAM during preflight phase.
Regards

[masterp]

Anyone got the problem which ND route is different on server PC and client PC.?
My route on ND (which on client PC) is not updated while the same ND.exe (which run from server PC) is updated fine.
It happened randomly while FMGS server restart a few times.


Above ND is run from server PC, below is runs from my client laptop.
Direct waypoint and ND route is not updated

[alamwuhk2a]

Hi,
I can also confirm that sometimes there is no EGT needle.

Also, after engines started, even with correct input of ZFW/CG on FUEL PRED page, there is still no S F nor Vapp speed calculation on PERF page. Also Vapp becomes 0 when speed is managed.

When using TRK/FPA, the green "bird" symbol on PFD seems too large.

During steep turns, Valphamax(red strip) increases but Valphaprot(yellow/black strip) doesn't, leading to actual stall before protections kick in. In reality, both Valphamax and Valphaprot should increase as both of them are computed from actual angle of attack.

Thanks JL for the great work!

[asessa]

Wow great news JL! Thank you so much

[Leonidas]

Wow great news JL! Thank you so much

What news do you mean?

[asessa]

What news do you mean?

This new version...sorry but i read it only today :P

[brianwilliamson]

Jon Luc, Many thanks for the latest upgrade. I have been very slow upgrading because of the major C of A on the aeroplane.


All seems to be working fine except the Starter does not want to shut down on my Server computer. It comes up an access violation 0364851C in MSGDLL.dll , which I have not as yet traced where it could have come from.


I have been testing for days to find out why I am losing FPS on the server computer running P3D v3.4. Nothing to do with JL's program, but it appears to be from Orbx YBBN program. I have been eliminating everything until I am only running the server with basically minimal graphics, which start at over 100fps at YBBN and after a short flight and go back and land on YBBN, the frame rate drops to around 20fps.


So that one still has me testing !!



Cheers..............Brian W.