A320 FMGS B48

[startrail]

Hi,

After installing a fresh B48.2 my Climb auto throttle does not engage despite setting throttles to climb detent.

Can anyone help.


Thanks

Mike

[startrail]

i have similiar problem...
autothrust randomly wont activated, especially after try stick overtake from autopilot

I have ave the same problem too

[romeow]

Hi everybody,

is it in some way possible to configure sidestick's red button by FMGS_config > Joysticks buttons so that you are able to disconnect both AP1 and AP2 by one button push (e.g. during short final) - ideally with the correct sounds (Cavalry and following TripleClick).
Thanks!
Regards
René

[jeehell]

ATHR which can not be engaged: check the ATHR disconnect pushbutton was but pushed fire me than 15s and also that it has a release action assigned.

AP1+2: the normal AP take over buttons should do that just fine?

[startrail]

ATHR which can not be engaged: check the ATHR disconnect pushbutton was but pushed fire me than 15s and also that it has a release action assigned.

AP1+2: the normal AP take over buttons should do that just fine?

Hi Jeehell ;

I can engage and disengage autothrottle from the relative button or disengage from red button on Throttle (fscockpit) it is only when requested to pull back to climb detent it does not engage as per FMGS speeds.


Thank you for the constant support.


Mike

[jeehell]

Hi Jeehell ;

I can engage and disengage autothrottle from the relative button or disengage from red button on Throttle (fscockpit) it is only when requested to pull back to climb detent it does not engage as per FMGS speeds.


Thank you for the constant support.


Mike

Do you have MAN TOGA or MAN FLX on the FMA when you start your takeoff?

[startrail]

Do you have MAN TOGA or MAN FLX on the FMA when you start your takeoff?

Hi,

MAN MCT blinks for split of a second then nothing appears on FMA in this specific place.

[jeehell]

in that case your THR LVR calibration is probably not good. Check it again, particularly the detents error zones.

[startrail]

in that case your THR LVR calibration is probably not good. Check it again, particularly the detents error zones.

I thought so in the first place and calibrated the THR LVR many times. What value would you recommend as detente error to try again. Thanks .

[jeehell]

I can't recommend any it's dependent on your hardware. There is some info in the documentation.