Results 1 to 2 of 2
  1. #1
    75+ Posting Member
    Join Date
    Jun 2011
    Location
    FRANCE
    Posts
    121
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Encoders - Digits delay

    Hi Nico,

    I switched directly from V.2.0.1 to V.3.13. When I rotate my MCP hardware encoders the PSX virtual display values are "moving" good, without any delay. However, my hardware displays have a frustrating delay which makes the selection quite difficult. Could you please check if something is wrong at PSXSeecon side ? At my side, I didn't change anything in my script regarding encoders or displays since version 2.0.1. I can't test pedestal displays because I don't have the hardware pedestal yet. Thanks in advance.

    Best regards
    Regards,
    Jean-philippe

  2. #2
    1000+ Poster - Fantastic Contributor kiek's Avatar
    Join Date
    Jan 2007
    Location
    Netherlands
    Posts
    1,984
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Encoders - Digits delay

    Hi,

    My MCP behaves as always, good...

    Like I wrote before, I'm not aware of any changes, since 2.0.1 wrt encoders. Have not heard any problems from "Perth" either.

    Best regards,

    Nico