Results 1 to 2 of 2
  1. #1
    25+ Posting Member


    wody's Avatar
    Join Date
    Oct 2008
    Location
    near MUNICH
    Posts
    51
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    F1 Mustang cockpit and Link2fs

    Hello,

    does anybody use Link2fs for the F1 Mustang with all the G1000 and switch panels. I plan to use Linda for inputs (USB HID) and need something to get my LED lit with output.

    Any other recommendation? I'm in the planning phase for all the interfacing. I have already dual yoke, rudder pedals and TQ. Shell is 80% ready. The switch panels and G1000 parts will come during the next months. So I have to be prepared. Unfortunately I'm no programmer, only some SIOC experience from my LVL-D 767 (Lekseecon).

    Any help, advice is appreciated.

    Thanks,
    Peter

  2. #2
    25+ Posting Member


    wody's Avatar
    Join Date
    Oct 2008
    Location
    near MUNICH
    Posts
    51
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: F1 Mustang cockpit and Link2fs

    Hi all,

    have to push up.....

    Unfortunately my panels for the cockpit are still not here, so I have to work on interfacing. My first attempt to understand how it works. My interest is in getting the few LED outputs to work. Mainly on the AP.

    I tried Link2FS with my P3DV3 and the Mustang running and could see some of selected extractions (eg.
    Would like to hear any advice but remember, I'm no programmer.

    Quite a lot I'm asking, but hoping for any help.

    Thanks
    Peter