Results 1 to 3 of 3
-
03-08-2017, 04:46 PM #1
- Join Date
- Mar 2017
- Location
- United Kingdom
- Posts
- 2
Getting stuck - outputting RPM values to Arduino LCD
Hi
First just want to say hello, I am new to the hardware side and tinkering with FS
I am trying to get RPM data to output to an Arduino LCD screen. I have tried a couple of approaches using variations of serial read, but the LCD will only return odd characters such as pi or chinese symbols.
I have tested it with simple strings sent from the serial monitor, this works fine. For example I can type in "<01234" and its ok. With the program though, the strange charcters show up.
I am using P3D 2.5 also.
Any suggestions on how I can get the RPM to show up?
-
03-10-2017, 02:53 AM #2
- Join Date
- Nov 2013
- Location
- Evansville, Indiana
- Posts
- 248
Re: Getting stuck - outputting RPM values to Arduino LCD
Make sure your baud rates match.
~Fess
-
03-10-2017, 08:02 AM #3
- Join Date
- Mar 2017
- Location
- United Kingdom
- Posts
- 2
Re: Getting stuck - outputting RPM values to Arduino LCD
Hi Fess_ter
This was exactly it, many thanks
www.ljcockpit.com is up , orders are now open :)
Ljcockpit G600 , GTN Stack , GFC...