Results 1 to 4 of 4
  1. 02-16-2017, 03:23 AM #1
    jabad
    jabad is offline
    Our new friend needs to reach 10 posts to get to the next flight level
    Join Date
    May 2016
    Location
    Barcelona
    Posts
    8
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    TOPCAT Performance

    Good Morning to everybody.

    I'm trying to use TOPCAT to calculate the Take-off & landing performance, CG, and Flex temps, but there's a huge difference on CG between the one calculated by TOPCAT and the calculated by jeheell MCDU, the same with the flex temp for example in topcat i got that the felx temp is +62º and the n1 is 82,3% if I introduce the flex Temp on the MCDU the N1 % adjusted is 85.2%.

    It's possible to use TOPCAT for this purpose?
    Reply With Quote Reply With Quote
  2. 02-20-2017, 02:43 AM #2
    digidax
    digidax is offline
    25+ Posting Member
    Join Date
    Jul 2015
    Location
    Germany/Saxony/EDCJ
    Posts
    71
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: TOPCAT Performance

    Good Morning,

    you have used this TOPCAT A320 aircraft configuration file?
    https://www.dropbox.com/s/nwyv3uacz2d07es/topcat.zip?dl=0

    best regards, Frank
    Prepar3D v5, Jeehell Ware latest Beta, all Skalarki P&P Panels, Active Sky, ASCA
    Reply With Quote Reply With Quote
  3. 02-21-2017, 03:34 AM #3
    jabad
    jabad is offline
    Our new friend needs to reach 10 posts to get to the next flight level
    Join Date
    May 2016
    Location
    Barcelona
    Posts
    8
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: TOPCAT Performance

    Yes, I'm using this one
    Reply With Quote Reply With Quote
  4. 02-22-2017, 12:25 PM #4
    jabad
    jabad is offline
    Our new friend needs to reach 10 posts to get to the next flight level
    Join Date
    May 2016
    Location
    Barcelona
    Posts
    8
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: TOPCAT Performance

    A real example today TOPCAT recommends a Flex take of with a Flex temp of +68º according TOPCAT N1 should be 80% when I introduce this temp on jeehell the FLEX N1 value showed on Engine screen was 83,6%

    with a ZFW of 61419 TOPCAT says that the trim condition is 33,88% jeehell CDU 33,2%
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »