Results 1 to 3 of 3
  1. #1
    Our new friend needs to reach 10 posts to get to the next flight level
    Join Date
    Jan 2017
    Location
    Germany
    Posts
    6
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Using "SimConnect Inputs" on Card2-5

    Hi Everyone,

    is there a way to use "SimConnect Inputs" on Card2-5?
    I can't find the "SimConnect Inputs" under "Experts" in the Card2-5 window. Or can any card send the "Y01"-"Y25"-commands?

    I am working inputs for a DA40 and will use two Arduino Mega both of which will use SimConnect Inputs.

    Many thanks for any helpful answer.

    Kind regards,
    Frank

  2. #2
    Our new friend needs to reach 10 posts to get to the next flight level
    Join Date
    Jan 2017
    Location
    Spain
    Posts
    7
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Using "SimConnect Inputs" on Card2-5

    I am doing a very similar build and the 25 simconnect inputs work for all card connected however the 25 inputs are not enough for me as a 737 NGX has over 90 inputs.

  3. Thanks Frank_P thanked for this post
  4. #3
    Our new friend needs to reach 10 posts to get to the next flight level
    Join Date
    Jan 2017
    Location
    Germany
    Posts
    6
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Using "SimConnect Inputs" on Card2-5

    thank you very much!