A320 FMGS B46

[gord0n]

Hi
Since 46, my MCDU (software jeehell component) present MCDU DISPLAY PROBLEM PLEASE REPORT ISSUE on PROG and PERF page
a try to uninstall reinstall and the issue is always up
Someone has an idea?
full thanks all

[jeehell]

You need to post more details on how it happens, at least at what stage of the flight/preparation you were, and what you were doing exactly.

[gord0n]

thanks for your anwser
i'd make a clean full install again and issue is solved.

However, how to make properly good running or config the gear, flaps, speedbrake softwares?

[anzabon]

Hello,

since a couple of days days I'm not able to start the FMGS system any more in cold'n'dark mode. I've de- and reinstalled the hole software on server and clients several times, have assigned all LED and switch inputs once again, have checked all network connections, LEDs and switches are connected successfully via FDS boards. Have lost three days with failure research but still no solution...

When I start FMGS in cold and dark mode with admin rights, the displays power up normally but after a 30 seconds there is a MASTER CAUTION coming up with these amber ECAM messages:

ENG1 SHUTDOWN | * AIR BLEED
XBLEED.......SHUT | * ELEC
ENG2 SHUTDOWN
XBLEED.......SHUT

STS page shows following amber messages in INOP SYStems:

SPLR3
ADR3
WING ANTI ICE
CAT 3 DUAL
APU BLEED
BRK ACCU
ENG1 BLEED
ENG2 BLEED
APU
PACK 1+2
CRG HEAT
CRG VENT
MAIN GALLEY
GEN1
GEN2

EXT PWR is installed, BATTs are showing 28V but I'm not able to start the APU - the APU MASTER switch doesn't illuminate, so it's impossible to get APU AVAIL.
XBLEED switch is AUTO, THR levers are idle as showed on EWD. Engine display is amber, FUEL PUMPS on, enough fuel is aboard. I've also tried with aircraft changing in FSX and back to Jeehell A320 in new flight configuration.

When I start FMGS with Engine Running, the APU can be started but cannot shut off: FLAP stays OPEN also when I switch APU MASTER to off. Rest of airplane reacts normally.

Very strange behaviour, I don't know how to solve that problem. Maybe some hints from the experts here?
Thanks in advance

Regards,
Bon

[OmniAtlas]

Have you tried running everything on one computer to see if it is a network problem?

[anzabon]

Thanks for replying
No, I haven't tried this. FMGSserver shows all software parts as "connected", and all other components are running properly. And in case of choosing "Starter with engines running", everything works fine...

I'll try it with software OVHD. Sounds to be a problem with the OVHD logic/connection here but why only with dark'n'cold?

Best regards
Bon

[jeehell]

Any chance you left P3D on pause ?

[anzabon]

No Sir, FSX is not paused

[jeehell]

do you have fire handles? if so try to remove their assignments.

[anzabon]

Yes, I have fire handles hardware. I will test that tomorrow morning and report. Still on late shift
Thank you very much so far

Kind regards
Bon