Results 1 to 2 of 2
  1. #1
    25+ Posting Member



    Join Date
    Mar 2009
    Location
    Argentina
    Posts
    27
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Post FSUIPC offset format error in Link2Fs Expert Mode

    Hi guys: i am trying to connect link2fs and arduino.
    I am using the expert mode and FSUIPC variable offset $3A98 and placing the "type" happen the following

    Type------Reset bar------------------- value
    Byte ------Green-----------------------oscillating and not real
    Double ----Red (say error in this line)---Correct Value
    Int32----- Green--------------------- -oscillating and not real
    Long------Green---------------------- Not real
    Short----- Green ----------------------oscillating and not real
    Single----- Red (say error in this line)-- oscillating and not real

    The same applies to other offsets.
    Thank you very much.

    Jose

  2. #2
    150+ Forum Groupie
    Join Date
    Feb 2007
    Location
    Argentina
    Posts
    204
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: FSUIPC offset format error in Link2Fs Expert Mode

    Jose:

    The same error with Link2Fs with other offsets, like turn coordinator ball (offset 036E).
    No way to obtain -128 extreme left, 0 center, or +127 extreme right.
    By the way, this was my first test with Link2FS, and some other offsets for drive servos in my Cessna 182 cockpit.
    This is the reason why I'm testing alternatives like ArduinotoSioc.

    Regards.
    Horacio.