Results 1 to 3 of 3
  1. #1
    25+ Posting Member
    Join Date
    May 2010
    Location
    Sydney
    Posts
    36
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Question Probelm with clean install of PSXseecon 3.2

    Hi Nico,
    I posted in the PSX forum but thought I'd put it here as well. The new 3.2 I downloaded yesterday does not create a default cfg file when run for the first time.
    I tried creating one but it does not seem to want to connect to PSX on the same machine (even if I use the correct IP address ie not localhost or 127.0.0.1)

    I will try again on my hardware machine after I have done a complete backup image.
    Cheers,
    Alex Boyd

  2. #2
    2000+ Poster - Never Leaves the Sim kiek's Avatar
    Join Date
    Jan 2007
    Location
    Netherlands
    Posts
    2,202
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Probelm with clean install of PSXseecon 3.2

    Hi Alex,

    When PSX, SIOC and PSXseecon are all on the same PC, it should work with no .cfg file.
    Otherwise, try with an empty PSXseecon.cfg. After a first run of PSXseecon, you should see two entries storing the main window position.

    Cheers,
    Nico

  3. #3
    25+ Posting Member
    Join Date
    May 2010
    Location
    Sydney
    Posts
    36
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Probelm with clean install of PSXseecon 3.2

    Thx Nico,
    I tried your empty file and it did add window positions.
    I will try again on my second hardware machine.

    Cheers,
    Alex B