Results 1 to 4 of 4
  1. #1
    New Member
    Join Date
    May 2016
    Location
    turkey
    Posts
    4
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    LCD display For COM1

    Hello dears,

    last two days I have trouble with lcd display. In Jims page I almost finished my project but all codes which shared on internet are generally with rotary and push buttons and they are very complicate. I try to read COM1 values from serial and print it to LCD display is there any example which is very simple for COM1 LCD display codes.

    regards

  2. #2
    150+ Forum Groupie


    BushPilotWannabe's Avatar
    Join Date
    Jan 2014
    Location
    Alberta, Canada
    Posts
    176
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: LCD display For COM1

    Hi Omar

    You can start with the demo http://www.jimspage.co.nz/Multi_Radio.htm and strip away unwanted controller codes, or try this zip taken from Jim's Radio Project which is the essence of everything that I have done and build your sketch from the ground up.
    Attached Files Attached Files
    ---CYXD ----- TWR --- GND ------ Closed
    ILS-- NDB -- 119.1 -- 121.9 ---- 11/2013

  3. Thanks heromur thanked for this post
    Likes heromur liked this post
  4. #3
    New Member
    Join Date
    May 2016
    Location
    turkey
    Posts
    4
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: LCD display For COM1

    Dear Hugh,

    this is exactly what I wanted, in first try it works. Yesterday I tried too much from
    http://www.jimspage.co.nz/Multi_Radio.htm but I think I delete more lines which I need. With your help I finished all codes now it is time to start design ( 737 Mcp ) my panel and some research DXF editing for laser cutting etc. anyway thnks your help .

    regards
    Omar

  5. #4
    150+ Forum Groupie


    BushPilotWannabe's Avatar
    Join Date
    Jan 2014
    Location
    Alberta, Canada
    Posts
    176
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: LCD display For COM1

    That's great Omar

    Think about how much work was required to take the seven switch inputs on one side and the twelve usb serial downloads on the other and then select and match them using one rotary switch.

    thanks Jim
    ---CYXD ----- TWR --- GND ------ Closed
    ILS-- NDB -- 119.1 -- 121.9 ---- 11/2013

  6. Thanks heromur thanked for this post
    Likes heromur liked this post