Results 1 to 2 of 2
  1. 04-28-2016, 11:18 AM #1
    Tobia346
    Tobia346 is offline
    Our new friend needs to reach 10 posts to get to the next flight level
    Join Date
    Nov 2015
    Location
    Ger
    Posts
    5
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Mycockpit.org No Spolier Reaction in P3D

    Hello Community,

    I am using JeeHell with Cockpitsonic hardware and in the hardware calibration window, the spoiler movement is visible and makes sense, while on P3D the Spoliers didn“t deploy manually, just on landing on armed Pos. What could be wrong here? Add: With the P3D command, they deploy.

    Best regards and thanks in advance.

    Tobi
    Reply With Quote Reply With Quote
  2. 04-28-2016, 01:27 PM #2
    TheLever
    TheLever is offline
    25+ Posting Member
    Join Date
    Aug 2012
    Location
    Copenhagen
    Posts
    26
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: No Spolier Reaction in P3D

    Hi Tobi,

    At the risk of sounding like a besserwizer since I am new to Jeehell, I would take a look at the calibration again. I had almost the same issue and found that it was due to too small neutral error percentages. When I looked at the calibration, the spoilers looked just fine, but they were not behaving in flight. My fix was to increase the neutral error parentage. Joe this helps!

    Thanks,
    Boaz
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »