A320 FMGS B45

[Mitch95]

Hello Micha,

Did you check IDX number of this 2nd MCDU ? It can't be the same one as 1st MCDU.
If I remember correctly, you can read it on SIOC window, and have to put it in SIOC_Creator.

Are your 2 MCDU plugged on the same computer, the one where SIOC.exe and SIOC_Creator.exe are runnning ?
I remember that it's easier to do so...

Regards,
Michel

[Airmichel]

Hello Michel,

the IDX numbers are correct, CPT has number 2 and FO number 3.
Both MCDUs are connected with the Sioc Computer.
The crazy thing is, the first MCDU works fine.
When I look in Sioc Monitor and Push a button on both MCDUs i have a button Event.

Regards

Micha

[iwik]

Hi Micha,
Have you had a look in the SIOC.ini file to make sure that the correct numbers are entered.
Also have you tried just assigning the FO one(not sure if you can do that) to see if it works on
its own.
The SIOC monitor only directly checks hardware and will still operate correctly if the sioc.ini
entries are incorrect.
Hope this helps
Regards
Les

[Airmichel]

Hi, Les

Yes! I check my sioc ini, but there is nothing looks like wrong.
Which numbers do you mean?
Can you post your Sioc ini to compare the files.

Regards

Micha

[iwik]

Micha,
Numbers i was referring to were Index and Device.
One other thing to make sure that nowhere in your SIOC script that you have defined the same
numbers for different functions. Because these could prevent the second uSBkeys card from working.
I dont have two MCDU's in my unit.
Les

[Airmichel]

Hi all Cockpit Builder,
Has anyone two MCDUs in his Cockpit?
When yes, can you show me your Sioc Script.
I hope anyone can help me!

Regards

Micha

[flykarli]

Hello Micha !
I have 2 MCDU's installed. I believe that only the keycard of the MCDU which is not connected to the server with an IDX number must enter, if I still remember correctly. Additionally, the IOCKey.exe must be running on the client computer. Hope you make it run. If necessary I send you tomorrow my Jeehellware.txt.
regards
Karl

[Airmichel]

Hello Karl,

I have both MCDU's connected (with USB) over the Server PC.
The Cpt an Fo Module from Jeehell is install on Client Pc.
I have three Beamer on Server Pc and no Inputs for MCDU Displays.
What is the right way to install two MCDU's with my Setup?

Regards

Micha

[flykarli]

Hello Micha!
As far as I know is only 1 Keycard on 1 PC run.
With me it is so that a keycard is connected to the server PC and a keycard on a client PC (USB). I have attached to you a few pictures of my Sioc config.




On the Client PC you must run the IOCKey.exe
The monitors can also be connected to a different PC. Of course the software of JeeHell MCDU Fo and Cpt must also be installed there.

Thats all, I hope this helps you.
regards
Karl

[tcane]

Have read anybody this note in the last Navigraph update?

"Changes to addon: Jeehell A320 FMGS
We have added communication/voice frequencies."
What does that mean?