Results 1 to 2 of 2
  1. #1
    New Member
    Join Date
    Nov 2015
    Location
    wisconsin
    Posts
    2
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Please help with n1% gauge

    Hello any help would be much appreciated. Ok so in link2fs expert I check the eng1 n1%. On the monitor I get values of $a000 to $a100 thats what im guessing is the n1% gauge value. I would like to take those values and control a servo with arduino mega 2560.

    How can I read that specific gauge. I got the flaps gauge to work. I just dont know how to read #a on the arduino

  2. #2
    New Member
    Join Date
    Nov 2015
    Location
    wisconsin
    Posts
    2
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Please help with n1% gauge

    OK so i found some code on here. i changed it to look for the n1%. in the code their is a serial.print. in the link2fx monitor i see the values are coming back as should 0-100. the problem im having is the servo is not moving just hums. the code is davide forcelline, modified by Ferry. i just changed it to look for #axxx. i think im not mapping the servo right or im not even close on some of the code. any help or input would be appreciated. thanks riddle