A320 FMGS B44

[Fritz]

I have upgraded from version 44.2 to 44.4 today. My ACC Press gauge stops working.
In the IPC console offset 73A7 delivers no value anymore. Is there something changed?

In the overhead the LED for Cargo Smoke FWD "DISCH" is permanently illuminated.
Even three LEDs, which I have assigned to MISC6 light continuously.
The LEDs are connected to a FDS-Sys 3 Board.

I'm going to start IIT Creator and save again.
Let's see if this helps.

[Fritz]

After I generated a new IIT.dnt with IITcreator the error with the permanent illuminating leds is corrected.
The problem with the offset 73A7 still remains.

Is the function already implemented that the trim wheels returns to 0 when landing?
I use the TL from Skalarki. With this it is not yet functioning.

[filippoporcari]

the trim resetting to 0 was implemented since some time ago then it stopped resetting...jl is aware of this.
i'm also using skalarki hw but the problem is not the hw: if u look the fctl page the trim does not reset in fmgs.
fil

[Miatanet]

After I generated a new IIT.dnt with IITcreator the error with the permanent illuminating leds is corrected.
The problem with the offset 73A7 still remains.

Is the function already implemented that the trim wheels returns to 0 when landing?
I use the TL from Skalarki. With this it is not yet functioning.

EDIT:
Now I see that you just have that issue after landing, right?

Hi Fritz
I am using Skalarki TQ too, and it works without any problems. Did you calibrate the trim wheels in IO Profiler?

BR
Stefan

[filippoporcari]

stefan,
we're talking about the trim resetting to zero RIGHT AFTER TOUCHDOWN.
it was correctly functioning before...not now: if u check the flight controls page on the system display the trim stays at the value used at touchdown and pf course skalarki hardware remains there and is not resetting.
how can your tq reset the trim to zero if the input is not given by fmgs?
regards
fil

[Miatanet]

Hi JL
after a clean install I am missing the starterfsx.exe and I guess that is why my parking brake is doing strange things (Skalarki HW).

Thank you for a short feedback.

BR
Stefan

[jeehell]

Hi

Since some versions now startedFSX disappeared since FS9 is no longer supported, only FDSX or P3D which use the same sim link (simconnect). You issues with park brake are not related to that....

JL

[OmniAtlas]

Hello, I've received my new FDS momentary switches for the GPWS / G/S -- the switch is now wired up.

I notice on startup the GPWS LED remains turned on for several seconds.

Is this normal behaviour in the real aircraft?

[OmniAtlas]

Flying with approach mode activated, then -> direct to waypoint

approach mode is deactivated, and speed restrictions reset to waypoint calculated on descent.

Should approach mode mode remain activated?

[jeehell]

HI

When you do the EGPWS tests, yes the LED will lit up for several seconds.
As for the APPR mode, you are talking abuot the FMGS one (not the FCU APPR bitton)?
It probably depends on which point the DIR TO is done? is it part of the APPR procedure?

JL