Results 1 to 4 of 4
  1. #1
    75+ Posting Member
    Join Date
    Dec 2013
    Location
    Germany
    Posts
    114
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Sioc + THR LVR Axe

    Hey there,

    I want to ask how to set the analoge axis from Sioc (USB Expension Card) in Thrust Lever (MAX REV,IDLE REV, IDLE, CL, MXT, TOGA). (FMGS_CONFIG)

    Thanks,
    Niklas

  2. #2
    75+ Posting Member
    Join Date
    Dec 2013
    Location
    Germany
    Posts
    114
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Sioc + THR LVR Axe

    Does nobody use the Opencockpits Expansion Cards Analoge Axis???

  3. #3
    2000+ Poster - Never Leaves the Sim
    Join Date
    Mar 2008
    Location
    France,Nice
    Posts
    2,426
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Sioc + THR LVR Axe

    Hi,

    You should do that as with a "regular" axis more or less:
    First make sure you declared the exapansion card in SIOC.ini, then setup the axis in SIOC creator.
    Run SIOC, then FMGS config then as with a joystick...

    JL

  4. Thanks Niklas thanked for this post
  5. #4
    75+ Posting Member
    Join Date
    Dec 2013
    Location
    Germany
    Posts
    114
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Sioc + THR LVR Axe

    Hi,

    Tanks for the reply. I will check this tomorrow.

    Niklas