Results 1 to 2 of 2
  1. #1
    10+ Posting Member
    Join Date
    Nov 2011
    Location
    UK
    Posts
    17
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Interface options?

    Hi folks,

    For my planned GA build I am planning on using mainly Bodnar cards for switches but for the switches that require LED indications such as gear & flaps I was planning on using arduino to handle both input and output. I was wondering though if it would be possible for the bodnar card to handle the gear switch while arduino handles the indications or will the switch need to be handled via the arduino also.
    Hope that makes sense.
    Many thanks
    Marc

  2. #2
    MyCockpit Support Staff


    Westozy's Avatar
    Join Date
    Nov 2005
    Location
    Perth, Western Australia
    Posts
    1,415
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Interface options?

    I suggest 1 x BU0836X card for your flight control inputs and 1 x FDS SYS card will do ALL your inputs and LED outputs. This is how I will be setting up my C172 sim after the Boeing is finished. Spend a little extra for this method and save yourself a lot of programming headaches!! Cheers Gwyn

    737NG using Prosim737, Immersive Calibration Pro, Aerosim Solutions motorized TQ & cockpit hardware, CP Flight MCP & FDS SYS1X, SYS2X & SYS4X, FDS PRO FMCs, AFDS units & Glarewings, Matrix Orbital ELEC display, Pokeys Landing & Cruise alt display, Buttkicker Gamers, 3 x BenqMW811ST projectors with a Matrox Th2Go
    http://www.aerosimsolutions.com.au
    Supporter of MyCockpit.org, please join me in donating!!!