Results 1 to 3 of 3
  1. #1
    75+ Posting Member
    Join Date
    Dec 2013
    Location
    Germany
    Posts
    114
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Programming Encoder with SIOC_Creator

    Hi,

    I want to programm the HDG Encoder and then I have 2inputs but only one input is asked by SIOC_Creator.
    I have the encoder(s) the MasterCard e.g. on Input 100 (Signal A) and 101(Signal B). The middle on GND of the groupe.
    Must I just set Input 100 or do I need a special card? And what must I set in the fields Acceleration and Direction?

    Thx.
    Niklas

  2. #2
    75+ Posting Member
    Join Date
    Dec 2013
    Location
    Germany
    Posts
    114
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Programming Encoder with SIOC_Creator

    Is my English too bad or does nobody know the answer?

  3. #3
    500+ This must be a daytime job



    Join Date
    Jan 2007
    Location
    NEW ZEALAND
    Posts
    867
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Programming Encoder with SIOC_Creator

    Hi Niklas,
    With Master cards the preferred encoder is the CTS288. Using other types of encoders
    may produce unpredictable results.
    When defining encoder inputs consecutive inputs must be used and you only have to
    specify the first input. Sioc automatically uses the next input.
    Hope this helps.
    Les

  4. Thanks Niklas thanked for this post