Results 1 to 4 of 4
  1. #1
    10+ Posting Member pablonator3000's Avatar
    Join Date
    Oct 2014
    Location
    Austria
    Posts
    24
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Thrust Lever Problem

    Hello
    I've got a little problem with my Jeehell FMGS Thrust Lever. When I try to start the engines, the ECAM says:" Start Fault, THR Lever not at IDLE ", but it is on IDLE. So I have a Screenshoot to show my problem exactly.
    Yours faithfully Pablo
    Attached Images Attached Images

  2. #2
    2000+ Poster - Never Leaves the Sim


    OmniAtlas's Avatar
    Join Date
    Jun 2012
    Location
    Sydney, Australia
    Posts
    2,049
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Thrust Lever Problem

    Try using an error zone of 1 in the joystick configure program if you are using the software based throttle lever.
    Soarbywire - Airbus Flight Simulation and Engineering | Jeehell FMGS - Free professional A320 avionics software for the cockpit enthusiast.


  3. #3
    25+ Posting Member
    Join Date
    Nov 2014
    Location
    China
    Posts
    48
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Thrust Lever Problem

    I have this too, but a quick wiggle of the throttles clears it. I keep meaning to go into the FMGS_config utility to increase the error margin but it's not high on the list.

  4. #4
    2000+ Poster - Never Leaves the Sim
    Join Date
    Mar 2008
    Location
    France,Nice
    Posts
    2,426
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Thrust Lever Problem

    Pablo,

    Jut to make sure, you did calibrate the throttle module in the FMGS Config? even if it's software based, it needs the calibration process.

    JL