A320 FMGS B40

[jeehell]

Hi,

I corrected the SIOC module which had a similar behavior.
Regarding the FSUIPC module, I will have to make a compromise, as the number of offsets possible does not make it easy to have pushed/released buttons easily. I'll correct that module later on.


@leonidas : can you elaborate?

Regards,
JL

[Leonidas]

Hi,
@leonidas : can you elaborate?
JL

When it starts it works as auto. It changes screens normally by itself (eg when I start APU, it shows APU screen). But if I press any button it shows ENG page and stays there, except I press ALL, it plays ALL changing pages every 1-2 sec and I can't stop it.
Regards

[OmniAtlas]

How are you guys setting up your Parking Brake?

Should you be saving the state of the aircraft with the parking brake turned on in the software, and programming the parking brake as an on/off switch or toggle?

Regards.

[Fritz]

Hi,

my CPFlight FCU is connected to Com Port 3. I have updated the firmware on JeeHell
Release 115. In the ini file I have insert Com Port 3.
In hardware connect my FCU does not connect.
If I test my FCU with the CPFlight test programm, all works right.
Has anyone else this problem in B40.1?

Regards.

[Leonidas]

Hi,
my CPFlight FCU is connected to Com Port 3. I have updated the firmware on JeeHell
Release 115. In the ini file I have insert Com Port 3.
In hardware connect my FCU does not connect.
If I test my FCU with the CPFlight test programm, all works right.
Has anyone else this problem in B40.1?
Regards.

Hi Fritz
I have same FCU, same firmware and with 40.1 works fine.
Regards

[Fritz]

I have completely relaunched my system.
Do you have a driver for the fcu installed ?

[Leonidas]

I have completely relaunched my system.
Do you have a driver for the fcu installed ?

No, I don't. No driver needed, except Jeehell DLL file included in B.40.1

[tcane]

Hi,

I corrected the SIOC module which had a similar behavior.

HI Jl,

ECAM seems to works now again only the HYD LED doesn´t work. But big thanks!

[Fritz]

No, I don't. No driver needed, except Jeehell DLL file included in B.40.1

I have deinstalled the hardware an connected the fcu again. I installed the cpflight usb driver. When I run FMGS it shows the following. Hardware connect says Port ist open, cpflight is "connected". FMGS Server says "not connected". Any idea what could be the problem?

[Leonidas]

I have deinstalled the hardware an connected the fcu again. I installed the cpflight usb driver. When I run FMGS it shows the following. Hardware connect says Port ist open, cpflight is "connected". FMGS Server says "not connected". Any idea what could be the problem?

Are you sure you start EXT PWR or APU?