A320 FMGS B40

[jeehell]

Hello all,

I will make more tests when I get the time.
However, I did try cockpitsonic hardware and using keyboard shortcuts keys and it worked...

Make sure the profiler has the correct sw dn and sw up events. If not, you will definitely have issues. Both events are very important.

JL

[Maddin91]

What do you mean by assigning keyboard shortcut keys? How's that gonna work?

Profiler is set up correctly, that's what we checked first.

[jeehell]

"Set Correctly" : can you put a screenshot of the profiler window for some of the ECAM switches?

[OmniAtlas]

Can someone confirm the following --

- When a button on the ECAM is toggled, the relevant page displays on the SD, and the LED of the button lights up.
- When the ALL button is pressed, after a button is selected, the ECAM pages roll through starting from the ENG page (along with the subsequent LED on the buttons light up), and stops at the selected ECAM page when the ALL button is depressed.

- If a button on the ECAM is not selected (default selection), and the ALL button is pressed and held, the SD rolls through each page selection, again starting from ENG, the LED on the buttons *do not light up*, and on depressing the ALL button, the page jumps back to the default page.

This is how my FDS ECAM connected by IITCreater is functioning with 40.1 update, and I am wondering if this is the correct representation. Thank you.

[Pim van Vrijaldenhoven]

Hallo JL,

In the profiler there are only UP/DOWN events for the ECAM ALL and the ECAM TO CONFIG buttons.

I am using the latest version of the profiler: 4.3.3100.1000

Best regards,

-pim

[jeehell]

@Pim: what about the other buttons? (I'm away with no means to check myself directly the profiler).

@Omni: this is almost all correct, except the ALL button should stop on the shown page as well if it was earlier in "auto" mode, and LEDs should turn on as well in that case.

JL

[Pim van Vrijaldenhoven]

Hallo JL,

The other ECAM buttons don't have a state. For examplë: [PEDESTAL] - ECAM COND

Best regards,

--pim

[Leonidas]

Hello all,
I will make more tests when I get the time.
However, I did try cockpitsonic hardware and using keyboard shortcuts keys and it worked...
Make sure the profiler has the correct sw dn and sw up events. If not, you will definitely have issues. Both events are very important.
JL

Sorry, what and where is this "profiler"? Is this for Cockpitsonic H/W too?

[jeehell]

The "profiler" is only for skalarki hardware.
I did test a cockpitsonic panel with latest version and it worked flawlessly.


JL

[tcane]

Hallo,
My Ecam with Opencockpits Hardware has also similar Problems. Only the ENG LED works... when i push the other buttons like Hydraulic etc. there nothing happens on the EWD/SD. Made a new Video by the time. I think it´s better for explain.

Cheers
Florian