Results 1 to 4 of 4
  1. #1
    75+ Posting Member
    Join Date
    Aug 2012
    Location
    New Zealand
    Posts
    124
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    ELEC 1 & 2 constant failure after update

    Hi guys,

    Not sure if this is a combination of things but since upgrading to version 38 and after having installed my new FCU, about 5 times in the last hour i get FAC 1 & 2 fault on me... i can remedy it easy enough in flight but why on earth does it keep turning itself off?

    I am using the 4.2 profiler..but other than start up i don't know much about it to be honest..

    Any ideas?

    Ta

    Doug

    PS -anyone have the MCDU from Skalarki as thinking of getting this too?

  2. #2
    10+ Posting Member
    Join Date
    Oct 2014
    Location
    Zurich
    Posts
    12
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: ELEC 1 & 2 constant failure after update

    I'm experiencing FAC 1 & 2 faults since the new Update to Version 38.
    When I switch it to OFF and then again to ON, everything is working fine for some minutes and then the FAC 1 & 2 faults again.

    Regards
    Manuel

  3. #3
    2000+ Poster - Never Leaves the Sim
    Join Date
    Mar 2008
    Location
    France,Nice
    Posts
    2,426
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: ELEC 1 & 2 constant failure after update

    Should be solved in next update, it seems when the CPU gets "stressed", the FAC think there is a power cut...

    JL

  4. #4
    75+ Posting Member
    Join Date
    Aug 2012
    Location
    New Zealand
    Posts
    124
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: ELEC 1 & 2 constant failure after update

    Thanks JL!!

    Thought my CPU was handling all this no problem! Yikes!