Results 1 to 3 of 3
  1. #1
    New Member
    Join Date
    Oct 2014
    Location
    Poland
    Posts
    2
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Exclamation Cessna 172/152 dimensions

    Hello everybody!

    I'm building yoke and rudder pedals controls for my university project of Cessna 172 Skyhawk simulator. Is there anyone that might have information about range of motion, spacing or dimensions of cessna controls? Anything would be usefull. Can't find any valuable information on the net. Links are almost always outdated.

    Thanks in advance,
    Adam

  2. #2
    150+ Forum Groupie
    Join Date
    Feb 2007
    Location
    Argentina
    Posts
    204
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Cessna 172/152 dimensions

    I have a manuals parts, operating handbook, and some skechts and photos, of c-172 and c-182. (same dimensions).
    I īm a pilot in real life too, flying a C-172 hawk XP, and building a cockpit of a C-182RG. In some place, i have measure the range of motion of the commands, etc....

    Check first:

    http://www.mycockpit.org/forums/showthread.php?t=17024

    http://www.mycockpit.org/forums/showthread.php?t=18233

    https://fsxtimes.wordpress.com/2014/...-measurements/

    (the photo gallery is not online, but i have some of them download anywhere in my PC) like this.
    If you are interested, let me know, and I will found, but give some time....
    Regards.
    Horacio.

    aaa.jpgaaq.jpgaar.jpg

  3. #3
    New Member
    Join Date
    Oct 2014
    Location
    Poland
    Posts
    2
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Cessna 172/152 dimensions

    Thank you for your replay.

    I am interested, of course! I will be grateful for anything.

    Right now the only thing I need the most is range of motion - angle and translation on both pedals and yoke to calculate which motor to use and what gear reduction I need to apply. Next thing is the spacing of rudder pedals.

Tags for this Thread