Results 1 to 3 of 3
  1. #1
    500+ This must be a daytime job



    Join Date
    Jan 2009
    Location
    Tampa
    Posts
    531
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Getting Started With LINK2FS - Question....

    Hi All,

    I am getting stated here with the Arduino and link2fs. I am an old hat with C, and have been doing microcontroller stuff for a long time, so this should not be a giant challenge. I have an Uno set up an have loaded the multi_keys_gearsimple ino file. I am able to raise/lower the gear by switching inputs 8 and 9 as indicated in the code. However, the pin for the gear up/down indication never changes state. The code seems to indicate that it is waiting for "2" or "1" to show gear-down or gear-up. The monitor on link2fs shows that it is sending
    Thanks,
    Buddy

  2. #2
    500+ This must be a daytime job



    Join Date
    Jan 2009
    Location
    Tampa
    Posts
    531
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Getting Started With LINK2FS - Question....

    Never mind, I found the issue. I was not seeing that you are supposed to use the ?Y extraction....

  3. #3
    150+ Forum Groupie
    Join Date
    Nov 2013
    Location
    Evansville, Indiana
    Posts
    243
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Getting Started With LINK2FS - Question....

    Welcome Buddym,

    Welcome to the dark, dark, path.



    ~Fess
    I will only ever be, half the Geek that I wished I was.
    TheGeekForge.Com

  4. Likes BuzziBi liked this post