A320 FMGS B36

[Miatanet]

Hi all
I had no issues at all. Updated yesterday to latest version, copied navdata folder to all systems and had a short flight from lszh to lsgg without passengers and without cargo. All went without any issue. I had inop crg heat too. When starting approach manual speed did not work first, but after disconnecting AP and activating again, speed via FCU in manual mode worked.

that really rocked, no more hardware.exe disconnects any more ������.

thank you so much again for that great software

kind regards
Stefan

[brianwilliamson]

I have tried every thing I can think of and have done half a dozen or more installs and updates to get to 36.4 but the overhead will still not work at all now, so it is worse than before. Still running 3 seperate computers on a full sized simulator.


I had a feeling the autoupdater was not doing things correctly this morning as it would take ages to load anything and then closed down. Later today it updated a lot faster and less updates, so something did not seem correct.


I also did the controls and buttons on the Server, so that was ok. It seems now the problem is with the Overhead and the FDS Cards. I sure do not wish to go through the lot of those again with that many buttons and Leds. !! It shows that they are connected and working .


It seems some things have changed in the last few updates, so perhaps I am missing something.


I have gone back to 34.1 and all works fine except for a couple of things that I suspect you have corrected in the later versions.

I am also using the latest version of P3D and have deleted FSX.

I will try again in the morning and see if I can get some further information to pass on.



Again many thanks, Regards.................Brian W.

[jeehell]

Brian,
Did you try the full package I uploaded yesterday evening?

Regards
JL

[brianwilliamson]

JL Yes I did.

Brian W,.

PS. Maybe not, I just checked and not sure will re-do in the morning................

[jeehell]

To all: there have been issues with some antivirus for a while. Some effects are files not being copied during installation or update. This can mean communication issues between the apps. So make sure you're not in that case.
Also, windows sometimes block the comm if the applications are not run with the same privileges. I recommend using administrator rights for all apps.

Regards,
JL

[brianwilliamson]

Thanks JL will check all the above.

Brian W.

[tcane]

Hi Jehell,
after your last update the jehell ware server says that the ewd, pfd, and nd on the client are not connected but all seems to be work fine. Is this normally?

thanks again for your hard work on this nice software! And off course that I controll the radio in smaller steps now!!! Perfect. I can turn now in frequencies like 132.155

cheers Florian

[stubenflieger]

Hi JL,

thak you for the last update. the 36.4 works.I just had a flight with conneced modules all the time!

in regards

markus

[filippoporcari]

just for info after the DLLs update i had NO HC CRASHES AT ALL after some 10 flights....VERY GOOD JOB!!!
thx a lot jl
fil

[brianwilliamson]

Went through everything and on all computers and exempted necessary programs on Windows Defender and turned off the firewalls, made all run as Administrator. Loaded 36.4 and all went well. everything connected as it should but could not get the APU Master Switch to operate.

I checked the overhead graphics with the Mouse and all Switches and Leds worked both on the graphics and my overhead Leds/switches. All except the APU Master switch. I even went back and re-saved the APU Master Switch in the hardware folder, but made no difference.


All parts checked as being connected ok.


So there is not much more I can tell at this stage, except to go back to the earlier version. I suspect there is just one setting that is incorrect, but hard to tell which one.


Regards and many thanks................Brian W.