A320 FMGS B36

[stubenflieger]

ok, now i have tried something different. i disconnected my third Monitor on the remote pc and did not connect it to the fsx pc. now everything works fine - no disconnects.

could that have been the reason? Maybe because the pc had more workload with the Monitor? it is a usb Monitor, so it has a Software graphics Card.

regards
markus

[Stephan Schwarz]

With the latest version installed (clean full install on all 3 computers), on the computer running both sides PFD and ND, the CPU load is always 100%. This makes the visuals laggy, which has not been before. Can you check this please, Jean Luc?

Thank you,
Stephan

EDIT: well, just went back to B36.3,, the CPU load was still between 95-100% ... so I kicked out the Dual Core AMD 6000+ and switched to a Quad core AMD X955 ... now the CPU load is between 50 and 60% and everything is running smooth ...

[jeehell]

Hi

- the msg mutex warning is not a sign of disconnection
- I have seen issues with administrator rights with last versions. Make sure you run ALL applications with admin rights. Make sure your antivirus does not block anything. Working on an earlier version is not a warranty it'll work just the same way with the new version.
- please try to copy the nav data on all your clients.
- if possible, put the ovhd on the server.
- I can certify the software works on a Sim with 4 networked PCs
- PFDs and ND do use a lot of CPU. No going back there.

Regards,
JL

[jeehell]

(the thread was closed unintentionally, just reopened it sorry...)

[Miatanet]

Hi JL
is there an ini file where you can set the active rmp frequency to unicom 122.800 as default?

BR
Stefan

[Beret]

Hi Stefan
Save your flight with 122.800 as your standard flight. I think it must work so.

BR
Guido

[jeehell]

Hi,

latest version is here:
http://www.jeehell.org/A320FMGS_B36.5.exe

regards,
JL

[lmaster]

Hi JL,

Just installed last version B36.5, using updater and reboot. However, your software boxes (for sound, Server, AP/FBW,...) are all indicating at the bottom version B36.4. Is this something I should not care about or does this means some kind of installation error?

I turn off A/V and firewall for installation/update.

Thanks.
Joao

[jeehell]

Do not care about that.

JL

[buentead]

Thank you, JL, for the software update! I did a flight from Zurich to London Heathrow without problems (2.5h online). Very cool!

There are 4 minor cases I noticed:
- Sometimes, E/WD duplicates the screen of SD. Usually, after a restart of both programs, E/WD will be correct
- On the SD page "Engine", the start valve position shows open and close (as a cross) when the valve supposed to be closed. The open position is correct.
- I have to run the WideFMGSServer with the Windows priority set to "Above Normal". If I don't change the priority, then the two clients may loose input connection to the server (if this happens, the output communication (from server point of view) still works).
- On the Skalarki ECAM, the light of the selected page doesn't show up. Only CLR and STS works.

Adrian