Results 1 to 2 of 2
  1. 12-09-2014, 12:59 AM #1
    az_91
    az_91 is offline
    New Member
    Join Date
    Dec 2014
    Location
    Maryland
    Posts
    3
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    LINK2FS software help

    Hello all.
    I'm having a problem with encoders, I have 3 encoders and everything is setup perfectly and they are connecting to FS9, however i am not sure how to set different functions for each... i.e: first encoder for heading, second for altitude...etc.

    I tried to search online and i couldnt figure it out. Any help would be great.

    Thank you again
    Reply With Quote Reply With Quote
  2. 12-10-2014, 02:01 AM #2
    az_91
    az_91 is offline
    New Member
    Join Date
    Dec 2014
    Location
    Maryland
    Posts
    3
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: LINK2FS software help

    Just an update, I kind of worked around this problem.... for anyone facing the same situation you should change the lines in the code being sent to arduino... not from link2fs.. for example:

    You find the line Serial.println (" ") in the encoder section and you place the key that you want to be sent between " ", the keys are found on link2fs .. for example

    Serial.println ("A57") for Heading bug
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Tags for this Thread