Results 1 to 3 of 3
  1. #1
    75+ Posting Member
    Join Date
    Jun 2011
    Location
    FRANCE
    Posts
    121
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Engine start switches

    I have a question about the Engine Start Switches. On my overhead they are replaced by push buttons for simplification. In your documentation you wrote these switches are "I" type. Is there a way to make push buttons doing the job ?

  2. #2
    2000+ Poster - Never Leaves the Sim kiek's Avatar
    Join Date
    Jan 2007
    Location
    Netherlands
    Posts
    2,202
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Engine start switches

    Quote Originally Posted by Jean-philippe View Post
    Is there a way to make push buttons doing the job ?
    Yes, I did the same. The SIOC code will be in the psxseecon package.

    Note that for Engine Start Switches this is even more complicated because they jump back in PSX if N2 reaches a certain value. So if one would be using On/Off switches one needs a solenoid or a servo to synhronise with PSX. I've just added information variables with the position of the start switches in PSX, so one can do this...

    But with push buttons this is easy.

    Nico

  3. #3
    75+ Posting Member
    Join Date
    Jun 2011
    Location
    FRANCE
    Posts
    121
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Engine start switches

    Thank you very much.