Results 1 to 2 of 2
  1. #1
    New Member
    Join Date
    Aug 2014
    Location
    Costa Rica
    Posts
    1
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    GOFLIGHT GF-RC CARD

    I have problems with the potentiometer of the rudder card of my GOFLIGHT GF-RC Pedals, is broken and it’s obsoleted. Any idea where I can find this card or how I can substitute this potentiometer, or how I can fix it?
    Thanks before hand for any help.

  2. #2
    500+ This must be a daytime job ian@737ng.co.uk's Avatar
    Join Date
    Jan 2006
    Location
    Oswestry, Shropshire
    Posts
    609
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: GOFLIGHT GF-RC CARD

    Hi Daniel....
    If the card is faulty then obviously it needs to be replaced. As you say the card is obsolete, then I would suggest using a BU0836 card from Leo Bodnar.
    Connection is not difficult, just needs some header plugs (supplied with card) soldering to the potentiometer leads.
    As far as the faulty pot is concerned, usually commercial company's tend to use standard components to make manufacturing easy. You should be able to find a suitable pot at a local electronics store.
    Connect the Rudder pot to the X or Y axis because in the Windows calibration menu, you can set a centre point.
    Hope that helps you out Cap'n
    Regards

    Ian
    Mr. Ian. P. Sissons is hereby recognised as an Honorary Flight Sim Captain following his passing in February 2016. This is in recognition for his commitment to Flight Simulation.

    www.mycockpit.org Featured Builder August 2008 www.737ng.co.uk
    FS9/PROSIM737/CPFLIGHT/Lots of BU0836X's and a Beer Fridge