Hi all!

[Sean Nixon]

Avro is right about ProSim, but you still need to select an aircraft model in FSX. You could use the default for that (or the stripped down PMDG), but ProSim have made their own called Jetstream. It's not part of the Prosim package, you need to buy it separately if you want it.

Good luck and happy building!

Sean

[made_rm]

Ok, so if i do not want to buy another package (PROSIM is already expensive alone ) I can select the 737 Default aircraft and that one will use automatically the engine provided by PROSIM, with all working switches, light etc. is it right?

If not your post did confuse me

[Sean Nixon]

Yes. Download the prosim demo and try it with the default 737. Works fine.

[made_rm]

Hi Sean, thanks for your quick reply!

I'm going to try the Demo... but once expired wich kind of licence should i buy?
From http://www.prosim737.com/shop/ is not clear.

for sure i need the display package, it it enough for the aircraft logic too or i need another package?

200€ i think is the maximum i can spend for this SW.

Regards,
m.

[Avro748]

(Accidental Double Post)

||| See the real post below |||
vvv.................................vvv

[Avro748]

If you can only spend 200, I would look elsewhere. You need all three to fully simulate the 737. Your other options are IFly CBE, which is about 350 Euro, and PM, which is outside almost anyone's budget. Maybe you should do another aircraft. If you like the A320, FMGS is free. It's the equivalent to Prosim. For MD80s, the Maddog has cockpit building support. If you like 767s, you can use Level D in conjunction with a program called Lekseecon to interface with your project. If you don't like any of those aircraft, you might want to think of other aircraft you might like, and I might be able to help you find the appropriate software.

[made_rm]

Hi Avro, if I have a physical MCP and CDU why I need these SW?
Sorry but even reading a lot I cannot understand why

[Avro748]

If you have a physical MCP and CDU, you still need the appropriate software to interface with. The CDU software will provide a display to show on the CDU screen, as well as all the logic. The MCP software will allow you to properly interface your physical MCP to the sim. Trust me, you need all three. The 3 in 1 bundle allows you to save money on them.

[made_rm]

600€ are really too much for non commercial use

i'll look for cheaper SW...

[Avro748]

It doesn't exist. That's the problem with niche markets.