Results 1 to 3 of 3
  1. #1
    10+ Posting Member
    Join Date
    Feb 2012
    Location
    France
    Posts
    24
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    STBY Engines Switch Var 99

    Hello Nico,

    I have the version 9.3 Lekssecon and FSUIPC 9.934. The SBTY Engines SW programming is:

    Var 99 Static name EngStbysw Link IOCARD_SW Input 35 Type P

    this button work correctly with Sioc Monitor. For information, the old programming via FSUIPC Virtual Joystick buttons is deleted
    This does not work.

    Thanks for the answer.

    Rgds
    Marc.

  2. #2
    2000+ Poster - Never Leaves the Sim kiek's Avatar
    Join Date
    Jan 2007
    Location
    Netherlands
    Posts
    2,198
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: STBY Engines Switch Var 99

    Hello Marc,
    I hope I understand your question.

    For your information: With Var 99 you can control whether the variables in section 4.16, such as 681, 682, 683, and so on, are showing information or not. It does not control whether the standby engine gauge in the Level-D panel is shown or not.

    You can control the gauge in the Level-d by defining a FSUIPC macro.

    Regards,
    Nico
    Last edited by kiek; 07-07-2014 at 02:36 AM.

  3. #3
    10+ Posting Member
    Join Date
    Feb 2012
    Location
    France
    Posts
    24
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: STBY Engines Switch Var 99

    Hello Nico,

    Ok. Programming macro FSUIPC.

    Thanks,
    Marc.