Results 1 to 3 of 3
  1. #1
    New Member
    Join Date
    Jun 2014
    Location
    Canada
    Posts
    2
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Problem with LeoBodnar BU0836X buttons

    Hello,

    I am using two of these boards. For one of them, when I press a button, it would stay on for a couple seconds after letting go. The joystick and POV controls work just fine.

    The other board works just fine, it doesn't have this delay.

    Has anyone else come across this problem before? Any ideas on what could be causing it?

  2. #2
    500+ This must be a daytime job



    Join Date
    Jan 2007
    Location
    NEW ZEALAND
    Posts
    867
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Problem with LeoBodnar BU0836X buttons

    Welcome,
    Are all the inputs the same?. Never had anything like this, the only possibility although never tried is that an input
    is configured for encoders. This board can have it's inputs as either switches or encoders. To set it for encoders one
    has to run the Utility from Leo's site to configure which inputs you want for encoders. Maybe worth making sure
    the inputs in question are set for switches.
    Les

  3. #3
    New Member
    Join Date
    Jun 2014
    Location
    Canada
    Posts
    2
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Problem with LeoBodnar BU0836X buttons

    Sorry for the late reply, I've been busy.

    I tried using the encoder utility and I get a message saying "Run-time error '380' Invalid property value" and then it shuts down.

    I tried it with the other board and it works just fine.