Results 1 to 3 of 3
  1. 03-19-2014, 10:48 PM #1
    OmniAtlas
    OmniAtlas is offline
    2000+ Poster - Never Leaves the Sim


    OmniAtlas's Avatar
    Join Date
    Jun 2012
    Location
    Sydney, Australia
    Posts
    2,107
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Hardware build recommendation

    I'm planning to build a cheap brand new computer to run all the display outputs for Jehell FMGS.

    That would include - 3x LCDs (PFD/ND - captain and FO side, EICAM, SD) and 2x CDU.

    I will plan on adding an additional graphics card; but in the mean time, would this AMD APU be sufficient?

    http://www.newegg.com/Product/Produc...82E16819113283

    It is the AMD A4-5300 and has a combined CPU+GPU built in. And its cheap!
    Reply With Quote Reply With Quote
  2. 03-20-2014, 01:23 AM #2
    Westozy
    Westozy is offline
    MyCockpit Support Staff
    Builder Of The Month / Point Value: 100
    Total Awards: 1
    Total Points: 100



    Westozy's Avatar
    Join Date
    Nov 2005
    Location
    Perth, Western Australia
    Posts
    1,415
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Hardware build recommendation

    Hi Ben, my own flight sim equipment philosophy especially with regard to your simulator's brain - re software, PCs and graphics. (Adopted from some good advice from Peter Cos by the way!) Work out your minimum requirements then buy three times better than what you need so you will have a few years of decent frame rates ahead of you. In other words, save where you can but don't skimp on the engine!!
    Cheers Gwyn

    737NG using Prosim737, Immersive Calibration Pro, Aerosim Solutions motorized TQ & cockpit hardware, CP Flight MCP & FDS SYS1X, SYS2X & SYS4X, FDS PRO FMCs, AFDS units & Glarewings, Matrix Orbital ELEC display, Pokeys Landing & Cruise alt display, Buttkicker Gamers, 3 x BenqMW811ST projectors with a Matrox Th2Go
    http://www.aerosimsolutions.com.au
    Supporter of MyCockpit.org, please join me in donating!!!
    Reply With Quote Reply With Quote
  3. 03-20-2014, 01:40 AM #3
    OmniAtlas
    OmniAtlas is offline
    2000+ Poster - Never Leaves the Sim


    OmniAtlas's Avatar
    Join Date
    Jun 2012
    Location
    Sydney, Australia
    Posts
    2,107
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Hardware build recommendation

    Hi Gwyn,

    I'm running on a 2500k intel with a 660TI OC on the main P3D computer (the 'visuals')
    I've successfully run Jeehells FMGS on my 4 year old Macbook Air without any slowdowns -- I don't really think it is very processor/video card hungry.

    I am unfamiliar with the new AMD APU and was wondering if they would be suitable? I could of course go with something with a little bit more power, but I would rather spend that money on other flight sim hardware
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »