Results 1 to 2 of 2
  1. 03-15-2014, 06:40 PM #1
    gspannelljr
    gspannelljr is offline
    75+ Posting Member


    Join Date
    Mar 2011
    Location
    Oklahoma
    Posts
    86
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    sioc script for tach

    I am working on writing a script for my servos card to drive a tach. below is what I have so far, I copied it and modified it from the info OC supplied. I don't know how to program the internal variables, L1, L2, and so on. I want to learn how to do this on my own. The script is valid but does not react to fsx correctly. Are there any scripts that I could refer to, or any reading that might help? Glenn
    Reply With Quote Reply With Quote
  2. 03-15-2014, 07:07 PM #2
    gspannelljr
    gspannelljr is offline
    75+ Posting Member


    Join Date
    Mar 2011
    Location
    Oklahoma
    Posts
    86
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: sioc script for tach

    I just did some testing and found out I can directly drive the air core gauge I have for the tach off the pwm signal from the usb card. I removed a dropping resistor in the gauge and it works fine to full scale, real stable. I plan to do that instead of converting the needle to a servo. Why do work you don't have to?
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »