Results 1 to 5 of 5
Thread: prosim 7837 IRS allign error
-
02-20-2014, 04:31 AM #1
- Join Date
- Nov 2009
- Location
- Bilbao - Spain
- Posts
- 31
prosim 7837 IRS allign error
hi guys:
i have one problem, when i start my 737 all is ok but IRS allign cascade fault in prosim737 failures page... if i reset it from FMC and delete, all displays begin to work, I think I´m doing everything OK, any sugestion??
SISMO MIP and OVHD, prosim737 and RSP throttle
Aitor
-
02-20-2014, 04:47 PM #2
Re: prosim 7837 IRS allign error
Are you moving the aircraft before the IRS is alinged? Takes about 10 minutes.
Best wishes, Peter
Building a B737NG - Blog: BuildABoing
-
02-25-2014, 04:42 PM #3
- Join Date
- Nov 2009
- Location
- Bilbao - Spain
- Posts
- 31
Re: prosim 7837 IRS allign error
no, i dont move it
-
02-26-2014, 07:53 AM #4
Re: prosim 7837 IRS allign error
I must admit that I not am good friends with the alignment process in Prosim. So often I end up resetting the failure in the Instructor Station.
My answer before was written from my phone, hence the shortness.
The alignment process is a rather lengthy one: From the B738 FCOM "Alignment time varies from five minutes to seventeen minutes depending on airplane latitude".
Three ways out of this:
If you start in "Cold & Dark" then make sure to do the alignment-proces in the right order.
Start in Ready-state. Then it should not be an issue.
Just delete them via the FMC.
I recommend you head over to the Prosim-forum. Lot of helpful guys overthere.Best wishes, Peter
Building a B737NG - Blog: BuildABoing
-
02-26-2014, 08:12 AM #5
- Join Date
- Nov 2009
- Location
- Bilbao - Spain
- Posts
- 31
Re: prosim 7837 IRS allign error
thanks Peter, will do..
nice flights!
Aitor
Embrace the freedom of casual encounters on the best dating app in town! One night stands, no...
Night games. No obligations. One...