Results 1 to 5 of 5
Thread: prosim 7837 IRS allign error
-
02-20-2014, 04:31 AM #1
- Join Date
- Nov 2009
- Location
- Bilbao - Spain
- Posts
- 31
prosim 7837 IRS allign error
hi guys:
i have one problem, when i start my 737 all is ok but IRS allign cascade fault in prosim737 failures page... if i reset it from FMC and delete, all displays begin to work, I think I´m doing everything OK, any sugestion??
SISMO MIP and OVHD, prosim737 and RSP throttle
Aitor
-
02-20-2014, 04:47 PM #2
Re: prosim 7837 IRS allign error
Are you moving the aircraft before the IRS is alinged? Takes about 10 minutes.
Best wishes, Peter
Building a B737NG - Blog: BuildABoing
-
02-25-2014, 04:42 PM #3
- Join Date
- Nov 2009
- Location
- Bilbao - Spain
- Posts
- 31
Re: prosim 7837 IRS allign error
no, i dont move it
-
02-26-2014, 07:53 AM #4
Re: prosim 7837 IRS allign error
I must admit that I not am good friends with the alignment process in Prosim. So often I end up resetting the failure in the Instructor Station.
My answer before was written from my phone, hence the shortness.
The alignment process is a rather lengthy one: From the B738 FCOM "Alignment time varies from five minutes to seventeen minutes depending on airplane latitude".
Three ways out of this:
If you start in "Cold & Dark" then make sure to do the alignment-proces in the right order.
Start in Ready-state. Then it should not be an issue.
Just delete them via the FMC.
I recommend you head over to the Prosim-forum. Lot of helpful guys overthere.Best wishes, Peter
Building a B737NG - Blog: BuildABoing
-
02-26-2014, 08:12 AM #5
- Join Date
- Nov 2009
- Location
- Bilbao - Spain
- Posts
- 31
Re: prosim 7837 IRS allign error
thanks Peter, will do..
nice flights!
Aitor
Looking for fun companions for travels and adventures? Authentic Ladies Premier Đ¡asual Dating
Top-notch Đ¡asual Dating -...