Results 1 to 4 of 4
  1. #1
    Have CNC-----will build.
    Join Date
    Oct 2009
    Location
    Leesburg, Florida
    Posts
    203
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    It has been quite awhile!!!

    Hello everyone!! I have not been on this forum in over 3 years now. I originally bowed out from my build for financial reasons, (bad economy, no job, etc.) I have since retired and am going to get started again. To start, has anyone seen, or used the Oculus Rift? I have one, and I must say, the immersion and 3D effect is quite nice. You can get information on the unit here: www.oculusvr.com. I wish there was a way to show everyone what it can and does do, it is quite amazing. You can fly in the 3D world with it on, but for now it is very difficult, if not near impossible to tune radios and other chores necessary in the cockpit. In the future, this may change. If there are any questions on the unit, post here and I will do my best to give you the information that I have so far.

    Milt

  2. #2
    150+ Forum Groupie


    Perik's Avatar
    Join Date
    Aug 2007
    Location
    NORWAY
    Posts
    229
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: It has been quite awhile!!!

    Hi Milt

    Long time no see....
    Great to have you back and I hope you this time get your project flying.

    About Oculus Rift there have been a few comment in here - do a search.
    A few of us are waiting for may be a more suitable product: CastAR.

    Look at this thread as well:
    http://www.mycockpit.org/forums/showthread.php?t=26832
    Regards,
    Per-Erik
    www.hoddo.net

  3. #3
    Executive Assistant Geremy Britton's Avatar
    Join Date
    Jul 2007
    Location
    North,East England
    Posts
    1,597
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: It has been quite awhile!!!

    Good to have you back, Welcome!
    Geremy Britton
    Executive Assistant, MyCockpit Inc
    Head of GLB Flight Products
    www.geremy.co.uk

  4. #4
    Forum Moderator
    Join Date
    Nov 2008
    Location
    Essex / EGMC
    Posts
    2,104
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: It has been quite awhile!!!

    Hey....great to see you again!

    I remember the small cnc parts you milled for me for my turn and slip gauge....I still have it!

    All the best!

    Alex
    Building An Airbus In My Garage!