Results 1 to 5 of 5
  1. #1
    300+ Forum Addict Avro748's Avatar
    Join Date
    Dec 2012
    Location
    At the Controls
    Posts
    347
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    OUT OF THIS WORLD NEW TOOL!

    Attention all CNC-less builders!

    For too long, we have forked out 50s on hole saws!
    The oppression ended when I was walking down the isle at Harbour Freight.
    I found this amazing little $6 device:

    This Adjustable Circle Cutter is PERFECT for 1/4" plywood or MDF. It goes anywhere from 1" to 5". The bit can easily be replaced, and the carbide tip blades can easily be removed and sharpened.

    The only thing to be wary of is to make sure you always drill on the same side, as it makes quite a mess of the exit hole.

    I've already drilled the holes for the ADI and HSI on the captain's side panel, and I'm quite satisfied.

    I just had to share this discovery with the public.

  2. Likes AK Mongo liked this post
  3. #2
    1000+ Poster - Fantastic Contributor
    Join Date
    Nov 2008
    Location
    Europe
    Posts
    1,934
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: OUT OF THIS WORLD NEW TOOL!

    I bought one of these back in 2008. I found it very un-accurate, as either side of the cutters needs to be exact to get a perfect cut, the cutters blunt quick, and if used with a hand drill, one slip and your hand is mush, it comes across to me as a very dangerous tool and I am scared to use it. I don't like the center drill piece as its a too bigger drill piece as when through the wood the cutter wobbles and you have to keep the drill dead straight to get a firm downward cut. It scares the living day out of me. I still prefer CNC by a long shot, but I am glad that you have had excellent results, just shows how bad I am with power tools haha!
    Last edited by CessnaGuy; 01-01-2014 at 07:25 AM.

  4. #3
    300+ Forum Addict Avro748's Avatar
    Join Date
    Dec 2012
    Location
    At the Controls
    Posts
    347
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: OUT OF THIS WORLD NEW TOOL!

    It's intended for use with a drill press. When you use a drill press, it works great.

  5. #4
    1000+ Poster - Fantastic Contributor
    Join Date
    Nov 2008
    Location
    Europe
    Posts
    1,934
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: OUT OF THIS WORLD NEW TOOL!

    Found it quite hard placing my Cessna MIP under a drill press, hence went cnc!
    Last edited by CessnaGuy; 01-01-2014 at 02:05 PM.

  6. #5
    300+ Forum Addict Avro748's Avatar
    Join Date
    Dec 2012
    Location
    At the Controls
    Posts
    347
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: OUT OF THIS WORLD NEW TOOL!

    I would use a CNC if I was willing to spend that time or money on it. I split my MIP into several parts that will come together later on.