Results 1 to 4 of 4
  1. #1
    150+ Forum Groupie
    Join Date
    Sep 2013
    Location
    Speyer, Germany
    Posts
    191
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Engine 2 start switch on after startup

    Hi everyone,

    When I start the Jeehell Software, the engine 2 start switch is on by default. Any idea if this is a known bug?

    Thank you,
    Stephan

  2. #2
    2000+ Poster - Never Leaves the Sim
    Join Date
    Mar 2008
    Location
    France,Nice
    Posts
    2,652
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Engine 2 start switch on after startup

    Hi,

    I have no ideas. Did you configure any hardware to this action?

    JL

  3. #3
    150+ Forum Groupie
    Join Date
    Sep 2013
    Location
    Speyer, Germany
    Posts
    191
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Engine 2 start switch on after startup

    This is independent, it happens when I have attached my Arcaze module and when not. Does your software read a switch status upon start and synchronizes wih the setting???

  4. #4
    2000+ Poster - Never Leaves the Sim
    Join Date
    Mar 2008
    Location
    France,Nice
    Posts
    2,652
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Engine 2 start switch on after startup

    Hi

    yes it could be the issue. The arcaze module is seen as a joystick with axes and buttons?

    JL