FSBUS components

[Kuba5]

Hi,
i need help with 6 compoments on FSBUS IO.

• L1 - 100uH coil. Please what max. voltage i need? Can i use this axial:
  https://www.gme.cz/tlec24-101k-p611-095 ?
  Or this:
  https://www.gme.cz/dpu100a1-p611-135 ? It's for max. 1A
• LED1, LED2 - which voltage and ampers?
• R12 - which resistor?
• C7 - which ceramic capacitor?
• can i use 5V/1A? Is 1A sufficient?

Thank you

[ciccio85]

L1 use low voltage....16 volts 36 volts...it's not important! Same for leds 5 volts leds are good. R12 22 ohms but my Io works with 120 ohm. C7 polyester capactitor. Use a stabilized power supply. For one card 1A is sufficient, but if you will use more cards, use a more powerfull power supply, i.e. a 5A. I'm using 10A power supply!! Important: use a switch to power on the COM board to avoid no constant power supply when power on; cid's are very sensitive to unstable power supply!

Ciccio