Results 1 to 2 of 2
  1. #1
    New Member
    Join Date
    Dec 2012
    Location
    Czech Republic
    Posts
    3
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    FSBUS components

    Hi,
    i need help with 6 compoments on FSBUS IO.




    Thank you

  2. #2
    10+ Posting Member
    Join Date
    Apr 2009
    Location
    Squillace
    Posts
    20
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: FSBUS components

    L1 use low voltage....16 volts 36 volts...it's not important! Same for leds 5 volts leds are good. R12 22 ohms but my Io works with 120 ohm. C7 polyester capactitor. Use a stabilized power supply. For one card 1A is sufficient, but if you will use more cards, use a more powerfull power supply, i.e. a 5A. I'm using 10A power supply!! Important: use a switch to power on the COM board to avoid no constant power supply when power on; cid's are very sensitive to unstable power supply!

    Ciccio