Results 1 to 2 of 2
  1. #1
    New Member
    Join Date
    Mar 2013
    Location
    Italia
    Posts
    1
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Initial Valur for rotary Control Variables

    Hi guys! I'm setting my lekseecon_f.ini in order to control my LevelD with my Saitek Switch Panel.

    I'm using the magnets knob of my panel to set the autobrakes. I filled my ini file as follows:

    Code:
    Autobrakes
    351 352 353 354 355
    But i obtained a warning
    ---> WARNING:
    No initial value info received for Rotary Switch 351:358, forced to 352 (most likely?)
    What can i do to set the initial valut of my rotary knob control variables?

    Thanks a lot guys!

  2. #2
    2000+ Poster - Never Leaves the Sim kiek's Avatar
    Join Date
    Jan 2007
    Location
    Netherlands
    Posts
    2,202
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Initial Valur for rotary Control Variables

    Hi,
    It is the responsibilty of your Saitek Switch Panel to fill the FSUIPC offsets, corresponding with the lekseecon variables you are using, before ( !) you start lekseecon_f.

    And of course afterwards, after each change in your switch panel, it has to set these FSUIPC offsets accordingly.

    Regards,
    Nico