Dual concentric rotary encoder with pushbutton

[birdyguy]

Hello everyone,

I'm looking for a source for dual concentric encoders with push button and threaded neck. Leo is sold out.

[fordgt40]

Opencockpits sell them

[birdyguy]

Opencockpits sell them

Thanks for your reply, but it seems they only sell the CTS288's. (single shaft)

[fordgt40]

sorry another senior moment

[birdyguy]

sorry another senior moment

You were trying to help. No worries Get those myself..too often it seems

[GlobalGentleman]

Depending on how badly you want/need them and are willing to pay, I know you can contact the sales department of Elma USA and make an order inquiry. Last I checked, they required a $100USD minimum order but were very friendly and helpful about it, even though it would've been a personal purchase (vs. corp purchase). At that minimum, you'd probably have an extra encoder and knob/cap left over for future use....good motivation for another future project lol.

If you go that route and can't find the email address on their website, PM me and I may still have it somewhere. Good luck!!

[geneb]

Stock is expected towards the end of April:

EC11EBB24C03 Alps Electric | Mechanical Encoders EC11EBB24C03 | Onlinecomponents.com

g.

[birdyguy]

Thanks very much for this info. I will contact them and try to place an order. $100 US isn't to steep an order as these items I think sell for around 12 to 15 dollars each and I need quite a few of them.

[nolatron]

Stock is expected towards the end of April:

EC11EBB24C03 Alps Electric | Mechanical Encoders EC11EBB24C03 | Onlinecomponents.com

g.

FYI regarding these encoders and OpenCockpits. These are the same ones I got with my ProSimParts radio panels. Out of the box they were pulsing twice per detent because they are 1/2 cycle encoders.

In order to get them to work correctly I needed to buy the OpenCockpits Encoder cards and reprogram the PIC chip with this code so they would only pulse 1 time per detent.

[birdyguy]

FYI regarding these encoders and OpenCockpits. These are the same ones I got with my ProSimParts radio panels. Out of the box they were pulsing twice per detent because they are 1/2 cycle encoders.

In order to get them to work correctly I needed to buy the OpenCockpits Encoder cards and reprogram the PIC chip with this code so they would only pulse 1 time per detent.

Thanks for info. Sounds complicated. I'm going to avoid that path if at all possible. I would like to get the Elma E37 duel concentric encoders with 16 detents on each shaft. Going to contact Elma and see if they will do a non commercial order.