Results 1 to 2 of 2
  1. 03-19-2013, 12:46 PM #1
    Henju
    Henju is offline
    75+ Posting Member
    Join Date
    Mar 2013
    Location
    Adelaide, South Australia
    Posts
    115
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Red face 737-500 Home Cockpit

    Right its settled, I'm making a 737-500 pit, now at this point your probably thinking same old build, but it's in Doha Qatar, and you can't get supplies like back home in Australia, you can't even get a simple 470 ohm resistor! Any way back to the subject, I will be making one functional side (capt) and the other will be not functional to save money, so whoever is flying will have to be in the capt seat, hopefully this will change as time goes on. All my products will be bought from open-cockpits, I am undecided weather to have two masters or one(tight budget!). My simple question is, does anyone have measurements of the 737-500 cockpit? It would be truly appreciated

    Thanks,
    P.S. I will upload some pictures to show my progress
    Reply With Quote Reply With Quote
  2. 03-19-2013, 02:51 PM #2
    Geremy Britton
    Geremy Britton is offline
    Executive Assistant Geremy Britton's Avatar
    Join Date
    Jul 2007
    Location
    North,East England
    Posts
    1,447
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: 737-500 Home Cockpit

    Have you checked the MyCockpit.org downloads library? ...

    Best of luck with the build,
    Regards
    Geremy Britton
    Executive Assistant, MyCockpit Inc
    Head of GLB Flight Products
    www.geremy.co.uk
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »